WoodworkingTips.com

Printer-Friendly Version Printer-Friendly Version

Small Parts Carousel

Example Drawing

I like to keep extra screws, bolts, and other hardware on hand to save me trips to the hardware store. The problem is all these parts can be difficult to store and organize. To solve this problem, I built the small parts storage carousel you see in the drawing to the right.

The carousel consists of a single base unit and a set of storage units sized to hold plastic bins. The storage units rotate so you can find the part you need quickly and easily. And, as shown in the drawing to the right, you can build and stack as many units as needed for additional storage.

Base. To make it easy to access the storage bins, I built a simple base (drawing below). First, cut the top and bottom shelves to size. And then connect them to the L-shaped legs and frame. Finally, add a lazy Susan to allow the unit to rotate.

Storage Unit. Each storage unit is built from 3/4″ plywood and 1/4″ hardboard. Start by cutting the base and top to size. Then make four separate storage compartments to hold two different sizes of 4″-wide bins (one deep and one shallow).

The two larger compartments are made by joining two sides and a divider to a back. Dadoes in the sides and back hold the 1/4″ hardboard shelves and divider (main drawing and inset below). The small center compartments are formed by connecting the backs of the large compartments by two spacers and a set of small shelves. Here again, dadoes hold the shelves in position.

To use the carousel, just slide in the bins and fill them with small parts. Then a spin is all it takes to find the part you need.

Drawing

Good woodworking,

Phil Huber
Editor, ShopNotes

Send for a preview issue of ShopNotes magazine

More Tips & Techniques
Index of Tips by E-mail
More Tips & Techniques
WoodNET, Woodworking on the Web
Subscriber Links
Update your Email Preferences
Subscribe

Small Shop Solutions Cuts Made Easy Best Shop Tips