Miter Clamping Jig

Gluing and clamping a single miter joint can be a challenge. It's often hard to get the joint lined up and then hold everything in place until the glue dries. To make this task easier, I built this clamping jig.

As shown in the drawing below, the jig consists of a large base of ³/₄″ plywood to support the pieces to be joined. A pair of triangularshaped blocks have a tongue at the bottom that slides in a groove in the base cleat to hold the pieces from the side. Sandpaper attached to one edge keeps the workpiece from slipping. A third triangular block travels on a T-track so it can be locked in place to secure the joint from the top. Before assembling the jig, I waxed all surfaces to prevent any glue from sticking to the parts.

To use the clamping jig, apply glue to the mitered ends. Now you can lay the two pieces on the base with the mitered edges pointing toward the bottom edge of the jig. Be sure to carefully center these pieces on the T-track.

Next, slide the inside clamping block against the workpieces and tighten the knob. Then move the outside clamping blocks into position and clamp them in place with a bar clamp. For maximum pressure, position the bar clamp near the base of the clamping blocks.

Now just let the jig hold the pieces in place until the glue dries.

drawings

Good woodworking,

Phil Huber
Editor, ShopNotes

Send for a preview issue of ShopNotes magazine

More Tips & Techniques: Index of Tips by E-mail; More Tips & Techniques; WoodNET, Woodworking on the Web

Subscriber Links: Update your Email Preferences; Subscribe


Woodsmith Magazine	ShopNotes Magazine	In the latest issue of ShopNotes: Hand-Cut Tenons Hobby Bench Sheet Metal Bending Brake Super Sawhorses Table Saw Dovetail Jig Send for a Preview Issue
Printer-Friendly Version Miter Clamping Jig Gluing and clamping a single miter joint can be a challenge. It's often hard to get the joint lined up and then hold everything in place until the glue dries. To make this task easier, I built this clamping jig. As shown in the drawing below, the jig consists of a large base of ³/₄″ plywood to support the pieces to be joined. A pair of triangularshaped blocks have a tongue at the bottom that slides in a groove in the base cleat to hold the pieces from the side. Sandpaper attached to one edge keeps the workpiece from slipping. A third triangular block travels on a T-track so it can be locked in place to secure the joint from the top. Before assembling the jig, I waxed all surfaces to prevent any glue from sticking to the parts. To use the clamping jig, apply glue to the mitered ends. Now you can lay the two pieces on the base with the mitered edges pointing toward the bottom edge of the jig. Be sure to carefully center these pieces on the T-track. Next, slide the inside clamping block against the workpieces and tighten the knob. Then move the outside clamping blocks into position and clamp them in place with a bar clamp. For maximum pressure, position the bar clamp near the base of the clamping blocks. Now just let the jig hold the pieces in place until the glue dries. Good woodworking, Phil Huber Editor, ShopNotes Send for a preview issue of ShopNotes magazine More Tips & Techniques Index of Tips by E-mail More Tips & Techniques WoodNET, Woodworking on the Web Subscriber Links Update your Email Preferences Subscribe
© August Home Publishing Company. All Rights Reserved. Privacy Policy \| Terms of Use \| Contact Us