Small Parts Clamp

When gluing and clamping small parts together, it’s always a challenge to align large clamps to hold them in place as the glue dries. To make this job easier, I built the small parts clamp you see in the photo above.

The base is two pieces of ¾″ plywood glued together and trimmed to size. Two grooves in the base hold a pair of T-tracks, as shown in the drawing below.

Next, two pieces of hardwood serve as the stop block and clamping block. They are drilled to hold flange bolts and two sections of threaded rod, as the illustration below.

Drawing

Place a T-nut in each hole at the back edge of the stop block, slide a threaded rod through the holes in both of the blocks, and then screw them into the T-nuts, like you see in the side view at left. A little epoxy at the end of the rod will keep it from turning. Next, slide the four flange bolts in the T-track, slip the blocks over the bolts and add the washers and wing nuts. Finally, add the washers and thread the knobs on the rod.

To use the clamp, loosen the wing nuts and place the parts to be clamped between the blocks. Position the front of the clamping block to extend slightly beyond the edge of the base so you can turn the knobs and secure the stop block in place. Finally, snug up the star knobs and tighten the wing nuts to lock the clamping block in place.

Good Woodworking,

Phil Huber
Online Editor, ShopNotes

Send for a preview issue of ShopNotes magazine

More Tips & Techniques: Index of Tips by E-mail; More Tips & Techniques; WoodNET, Woodworking on the Web

Subscriber Links: What's This?; Update your Email Preferences; Subscribe


Woodsmith Magazine	ShopNotes Magazine	In the latest issue of ShopNotes: Handsaw Miter Box Perfect Mitered Molding Table Saw Project Center Wall-Mounted Clamp Rack Send for a Preview Issue
Printer-Friendly Version Small Parts Clamp When gluing and clamping small parts together, it’s always a challenge to align large clamps to hold them in place as the glue dries. To make this job easier, I built the small parts clamp you see in the photo above. The base is two pieces of ¾″ plywood glued together and trimmed to size. Two grooves in the base hold a pair of T-tracks, as shown in the drawing below. Next, two pieces of hardwood serve as the stop block and clamping block. They are drilled to hold flange bolts and two sections of threaded rod, as the illustration below. Place a T-nut in each hole at the back edge of the stop block, slide a threaded rod through the holes in both of the blocks, and then screw them into the T-nuts, like you see in the side view at left. A little epoxy at the end of the rod will keep it from turning. Next, slide the four flange bolts in the T-track, slip the blocks over the bolts and add the washers and wing nuts. Finally, add the washers and thread the knobs on the rod. To use the clamp, loosen the wing nuts and place the parts to be clamped between the blocks. Position the front of the clamping block to extend slightly beyond the edge of the base so you can turn the knobs and secure the stop block in place. Finally, snug up the star knobs and tighten the wing nuts to lock the clamping block in place. Good Woodworking, Phil Huber Online Editor, ShopNotes Send for a preview issue of ShopNotes magazine More Tips & Techniques Index of Tips by E-mail More Tips & Techniques WoodNET, Woodworking on the Web Subscriber Links What's This? Update your Email Preferences Subscribe
© August Home Publishing Company. All Rights Reserved. Privacy Policy \| Terms of Use \| Contact Us