Printer-Friendly Version Printer-Friendly Version

Adjustable Planer Tables


My portable planer works great for planing lumber to final thickness. The problem is, the short infeed and outfeed tables make it difficult to support long workpieces. So I built the extended infeed/outfeed tables for my planer shown in the photo above. There is a table on each side of the planer that can be easily adjusted to match the height of the planer table. The added support at both ends keeps the workpiece from dipping and virtually eliminates snipe.

Best of all, it doesn’t take long to build. All you need is some ¾″ plywood, carriage bolts, and nuts and washers from the hardware store.


The base of the table is simply a piece of plywood made to fit on your supporting table or workbench. You’ll want it to be wide enough to mount your portable planer to the base.

Next, drill four counterbored 3/8″-dia. holes at each end of the base. Be sure to position them so they remain outside the path the workpiece needs to travel as it enters and leaves the planer. These holes will accept the carriage bolts used to support and adjust the infeed and outfeed tables.

Extension Tables

The infeed and outfeed tables are made by cutting two smaller pieces of plywood and drilling holes that correspond to the holes in the base (see detail ‘b’ below). Then it’s just a matter of adding the bolts, washers, and nuts, as you see in detail ‘a’ below.

Now, mount your planer in the center of the base. Position it so that the tables on your portable planer are spaced evenly in the opening between the adjustable infeed and outfeed tables at each end.


Table Adjustment

Finally, you’ll need to adjust the height of the infeed and outfeed tables to match the height of the planer tables. This is done by either raising or lowering the adjustment nuts at the corners of each extension table until the tables are flush.

Now, planing long stock has become a lot easier. The workpiece feeds flat and level, and I worry less about snipe at the ends of each piece.

Good Woodworking,

Phil Huber
Online Editor, ShopNotes

Send for a preview issue of ShopNotes magazine

More Tips & Techniques
Index of Tips by E-mail
More Tips & Techniques
WoodNET, Woodworking on the Web
Subscriber Links
Update your Email Preferences

Small Shop Solutions Cuts Made Easy Best Shop Tips